The Scanmar 40 is well-powered with enough sail area to move in light air, with acceptable motion comfort for coastal passages, and respectable in club racing.
Hull Speed
The theoretical displacement-mode speed limit — determined by waterline length, not engine or sail power.
A displacement hull pushes a bow wave whose speed is limited by the waterline length.
With a waterline of 34.2′, the Scanmar 40 tops out around 7.8 knots in displacement mode — after that, the bow wave outruns the hull and resistance climbs steeply.
1.34 × √34.2′ LWL = 7.8 kts
Performance Ratios
Racing handicap, sail-carrying power, stability and comfort — and what each one actually tells you about a day on the water.
PHRF Rating
102s/nm
Cruiser/racer — competitive in club racing, comfortable cruising.
SA / Displacement
19.1
Powerful cruiser/racer — quick in light air, reef early when it pipes up.
Ballast / Displacement
46.7%
Race-oriented ballast ratio — very stiff and powerful.
Displacement / Length
185
Moderate — a good balance of speed and load-carrying ability.
Comfort Ratio
24.3
Acceptable coastal comfort — fine for weekends, notice the chop offshore.
Capsize Screening
1.99
Below the 2.0 offshore threshold — acceptable for ocean passages.
Pounds/Inch Immersion
1lbs
Weight needed to sink the hull one inch — loading sensitivity.
Motion & Offshore Suitability
Two ratios that matter most when you're planning passages — how the boat feels in a seaway, and whether the hull geometry is suitable for open ocean.
Comfort Ratio
24.3
Acceptable coastal comfort — fine for weekends, notice the chop offshore.
Under 20 — Snappy, racing motion
20–30 — Acceptable coastal
30–40 — Good offshore comfort
Over 40 — Very comfortable offshore
Capsize Screening Formula
1.99
Below the 2.0 offshore threshold — acceptable for ocean passages.
Under 2.0 — Acceptable for offshore
Over 2.0 — Coastal / protected waters
PHRF Fleet Position
Where the Scanmar 40 sits on the PHRF handicap spectrum — lower numbers mean faster boats.
Racer 0–90
Cruiser/Racer 90–150
Cruiser 150–210
Scanmar 40
102s/nm
Cruiser/racer — competitive in club racing, comfortable cruising.
Estimated Speed by Wind
Rough boat speed estimates at different true wind speeds and points of sail — derived from hull speed, SA/D, and displacement, not measured polars.
| Point of Sail |
6 kts TWS |
10 kts TWS |
15 kts TWS |
20 kts TWS |
| Close-hauled40–50° |
3.3 |
4.2 |
4.7 |
4.9 |
| Close Reach60° |
4.0 |
5.1 |
5.6 |
5.9 |
| Beam Reach90° |
4.9 |
6.2 |
6.9 |
7.5 |
| Broad Reach120–135° |
4.5 |
5.7 |
6.4 |
6.9 |
| Run150–180° |
3.6 |
4.6 |
5.1 |
5.3 |
These are simplified estimates based on hull speed (7.8 kts),
SA/D (19.1), and empirical efficiency curves — not instrument-measured
polars. Real-world speed varies with sea state, bottom condition, sail trim, and current.
Speeds in gold approach hull speed;
bold gold means near or at hull speed.
Wind Range & Comfort Envelope
Estimated wind ranges for comfortable sailing on the Scanmar 40 — based on sail area, ballast, and displacement characteristics.
Ghost
Sweet Spot
Reef
Heavy
0–6 kts
6–20 kts
20–30 kts
30+ kts
Ghosting
0–6 kts
Light air, motor-sailing likely. Need patience and a light genoa.
Sweet Spot
6–20 kts
Comfortable under full sail. Best speed-to-comfort ratio.
Time to Reef
20–30 kts
Time to shorten sail. Reef the main, swap to a working jib.
Heavy Weather
30+ kts
Storm conditions. Storm jib or bare poles. Seek shelter if coastal.